National Loop Co. 88' (6' X 38') Saw Cut Vehicle Detection Loop with 20' Lead-In for 44' Wide Driveways - P-NL44-18-20

National Loop Co. 88' (6' X 38') Saw Cut Vehicle Detection Loop with 20' Lead-In for 44' Wide Driveways - P-NL44-18-20

For automatic gates that must satisfy UL 325, the National Loop Co. 88' Saw Cut Vehicle Detection Loop with its 20' lead-in detects a vehicle the instant it rolls over the wire, counts as one of the two means of entrapment protection UL 325 expects from automatic gates. Installers groove the existing drive, tuck the loop into the slot, and close it up with loop sealant. With 88' of wire laid out 6' x 38', it covers the lane on 44' wide driveways such as warehouse entrances, farm commodity yards, and municipal drives.
Part Number: P-NL44-18-20
$216.31 each $216.31 each
OR

Details

National Loop Co. 88' (6' X 38') Saw Cut Vehicle Detection Loop with 20' Lead-In for 44' Wide Driveways - P-NL44-18-20

Made for gate and access-control upgrades, the National Loop Co. 88' Saw Cut Vehicle Detection Loop with 20' Lead-In is an 18 AWG inductive loop, machine-wound and ready to seal into existing pavement. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. Installation calls for sawing a 1/8" slot 1" deep into existing asphalt or concrete, laying the loop in the slot, and sealing it, with no hand-winding or turn counting required. Its 38' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to logistics/warehouse entrances, large farm commodity yards, and wide municipal entries.

Features:

  • Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations

Specifications:

  • Loop type: Saw cut
  • Total loop length: 88'
  • Loop dimensions: 6' x 38'
  • Lead-in length: 20'
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 44'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL44-18-20?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 20'
Loop Length Size 6' X 38'
Total Loop Length 88'
Wire Size 1/8"
SKU P-NL44-18-20
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC