National Loop Co. 88' (6' X 38') Saw Cut Vehicle Detection Loop with 175' Lead-In for 44' Wide Driveways - P-NL44-18-175

National Loop Co. 88' (6' X 38') Saw Cut Vehicle Detection Loop with 175' Lead-In for 44' Wide Driveways - P-NL44-18-175

Behind every loop detector sits a coil of wire, and the National Loop Co. 88' Saw Cut Vehicle Detection Loop with its 175' lead-in detects a vehicle the instant it rolls over the wire. You saw a thin slot in the existing drive, drop the loop in, and seal it, with no demolition required. The 6' x 38' rectangle carries 88' of detection wire, sized to 44' wide driveways at warehouse entrances, farm commodity yards, and municipal drives.
Part Number: P-NL44-18-175
$287.35 each $287.35 each
OR
 

Details

National Loop Co. 88' (6' X 38') Saw Cut Vehicle Detection Loop with 175' Lead-In for 44' Wide Driveways - P-NL44-18-175

Installing the National Loop Co. 88' Saw Cut Vehicle Detection Loop with 175' Lead-In means sawing one slot, laying in a preformed 18 AWG loop, and sealing it. Once a loop detector reads its signal, the loop provides the non-contact vehicle detection automated gates rely on. Installation calls for sawing a 1/8" slot 1" deep into existing asphalt or concrete, laying the loop in the slot, and sealing it, with no hand-winding or turn counting required. Its 38' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to logistics/warehouse entrances, large farm commodity yards, and wide municipal entries.

Features:

  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations

Specifications:

  • Loop type: Saw cut
  • Total loop length: 88'
  • Loop dimensions: 6' x 38'
  • Lead-in length: 175'
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 44'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL44-18-175?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 175'
Loop Length Size 6' X 38'
Total Loop Length 88'
Wire Size 1/8"
SKU P-NL44-18-175
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC