Details

National Loop Co. 80' (6' X 34') Saw Cut Vehicle Detection Loop with 200' Lead-In for 40' Wide Driveways - P-NL40-18-200

Designed to sense vehicles without any surface teardown, the National Loop Co. 80' Saw Cut Vehicle Detection Loop with 200' Lead-In is a preformed 18 AWG loop that drops into a saw-cut slot. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. The install method is a 1/8" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. With the 34' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits distribution centers, heavy equipment dealerships, and semi-truck yards.

Features:

• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail

Specifications:

• Loop type: Saw cut
• Total loop length: 80'
• Loop dimensions: 6' x 34'
• Lead-in length: 200'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 40'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes