National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with 225' Lead-In for 38' Wide Driveways - P-NL38-18-225

National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with 225' Lead-In for 38' Wide Driveways - P-NL38-18-225

Hands-free gate operation depends on trustworthy detection, and the National Loop Co. 76' Saw Cut Vehicle Detection Loop with 225' of lead-in wire catches every vehicle that crosses its rectangle. Retrofit jobs go quickly, since the loop simply presses into a saw-cut slot and seals in place. Shaped as a 6' x 32' rectangle, its 76' of wire suits 38' driveways such as wide equipment yards and grain elevators or agricultural co-op entrances.
Part Number: P-NL38-18-225
$289.20 each $289.20 each
OR
 

Details

National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with 225' Lead-In for 38' Wide Driveways - P-NL38-18-225

The National Loop Co. 76' Saw Cut Vehicle Detection Loop with 225' Lead-In is a preformed 18 AWG inductive vehicle detection loop that arrives ready to drop into a saw-cut slot. Once a loop detector reads its signal, the loop provides the non-contact vehicle detection automated gates rely on. The install method is a 1/8" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. Its 32' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to wide equipment yards, grain elevators, agricultural co-op entrances, and large commercial plaza entries.

Features:

  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
  • Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
  • Neatly stacked turns accept loop sealant completely, locking out moisture for long service life

Specifications:

  • Loop type: Saw cut
  • Total loop length: 76'
  • Loop dimensions: 6' x 32'
  • Lead-in length: 225'
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 38'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL38-18-225?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 225'
Loop Length Size 6' X 32'
Total Loop Length 76'
Wire Size 1/8"
SKU P-NL38-18-225
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC