Details

National Loop Co. 64' (6' X 26') Saw Cut Vehicle Detection Loop with 50' Lead-In for 32' Wide Driveways - P-NL32-18-50

Sized to match a specific driveway width, the National Loop Co. 64' Saw Cut Vehicle Detection Loop with 50' Lead-In is a factory-wound 18 AWG loop for retrofit installations. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. Setup is a 3-step process: saw a 1/8" slot 1" deep in the pavement, press the loop in, and seal over it. Its 26' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to light industrial driveways and church or school lot entries.

Features:

• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
• Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
• Optimizes read range, eliminates faulty signals, and minimizes callbacks

Specifications:

• Loop type: Saw cut
• Total loop length: 64'
• Loop dimensions: 6' x 26'
• Lead-in length: 50'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 32'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes