Details

National Loop Co. 64' (6' X 26') Saw Cut Vehicle Detection Loop with 225' Lead-In for 32' Wide Driveways - P-NL32-18-225

Gate installers can turn an existing driveway into part of the safety system with the National Loop Co. 64' Saw Cut Vehicle Detection Loop with 225' Lead-In, a preformed 18 AWG inductive loop. Teamed with a loop detector, it gives the gate operator the presence detection UL 325 counts as one of its two means of entrapment protection, so the gate reverses or holds open while a vehicle sits in the path. Installers saw a 1/8" by 1" deep slot into the existing surface, drop the prewound loop in, and seal the slot against moisture. Its 26' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to light industrial driveways and church or school lot entries.

Features:

• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

• Loop type: Saw cut
• Total loop length: 64'
• Loop dimensions: 6' x 26'
• Lead-in length: 225'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 32'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes