National Loop Co. 64' (6' X 26') Saw Cut Vehicle Detection Loop with 200' Lead-In for 32' Wide Driveways - P-NL32-18-200
Details
National Loop Co. 64' (6' X 26') Saw Cut Vehicle Detection Loop with 200' Lead-In for 32' Wide Driveways - P-NL32-18-200
A preformed 18 AWG inductive loop built for saw-cut installation, the National Loop Co. 64' Saw Cut Vehicle Detection Loop with 200' Lead-In detects vehicles passing over the driveway. Once a loop detector reads its signal, the loop covers the non-contact vehicle detection that UL 325 requires as one of the two means of entrapment protection for automated gates. Setup is a 3-step process: saw a 1/8" slot 1" deep in the pavement, press the loop in, and seal over it. Its 26' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to light industrial driveways and church or school lot entries.
Features:
- Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
- More cost-effective than hand-wound loop installations
- Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
- Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
- Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
- Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
- Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
Specifications:
- Loop type: Saw cut
- Total loop length: 64'
- Loop dimensions: 6' x 26'
- Lead-in length: 200'
- Slot size: 1/8" wide x 1" deep
- Wire gauge: 18 AWG
- Wire material: Polypropylene-wrapped copper wire
- Best-suited driveway width: 32'
- Manufacturer: National Loop Company (NLC)
- Made in America: Yes
| Loop Type | Saw Cut |
|---|---|
| Lead-In Length | 200' |
| Loop Length Size | 6' X 26' |
| Total Loop Length | 64' |
| Wire Size | 1/8" |
| SKU | P-NL32-18-200 |
| Product Type | Saw Cut Preformed Loop |
Made In America
Learn More About BABA Certification
|
Yes |
| Ideal Application | Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters |
| Material | Polypropylene-Wrapped Copper Wires |
| Manufacturer | National Loop Company - NLC |
| Specification Sheet | Download PDF file |