Details

National Loop Co. 60' (6' X 24') Saw Cut Vehicle Detection Loop with 20' Lead-In for 30' Wide Driveways - P-NL30-18-20

Wound from one continuous length of 18 AWG wire, the National Loop Co. 60' Saw Cut Vehicle Detection Loop with 20' Lead-In installs in an existing paved surface through a simple saw-cut slot. Teamed with a loop detector, it gives the gate operator the presence detection UL 325 counts as one of its two means of entrapment protection, so the gate reverses or holds open while a vehicle sits in the path. Setup is a 3-step process: saw a 1/8" slot 1" deep in the pavement, press the loop in, and seal over it. The 24' side covers the travel lane with roughly 3' of clearance on each side, and the 6' side reads vehicles as they roll through, making it a fit for double-wide commercial entrances, equipment yards, and storage facilities.

Features:

• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of XLP-insulated wire, leaving no splice point between the loop and lead-in to fail
• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
• Neatly stacked turns accept loop sealant completely, locking out moisture for long service life

Specifications:

• Loop type: Saw cut
• Total loop length: 60'
• Loop dimensions: 6' x 24'
• Lead-in length: 20'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 30'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes