Details

National Loop Co. 56' (6' X 22') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 28' Wide Driveways - P-NL28-18

Contractors reach for the National Loop Co. 56' Saw Cut Vehicle Detection Loop with Custom Length Lead-In when an existing asphalt or concrete drive needs reliable vehicle detection. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. Setup is a 3-step process: saw a 1/8" slot 1" deep in the pavement, press the loop in, and seal over it. Its 22' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to apartment complex entrances and farm or agricultural property gates.

Features:

• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail

Specifications:

• Loop type: Saw cut
• Total loop length: 56'
• Loop dimensions: 6' x 22'
• Lead-in length: Custom length
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 28'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes