Details

National Loop Co. 52' (6' X 20') Saw Cut Vehicle Detection Loop with 75' Lead-In for 26' Wide Driveways - P-NL26-18-75

A preformed 18 AWG inductive loop built for saw-cut installation, the National Loop Co. 52' Saw Cut Vehicle Detection Loop with 75' Lead-In detects vehicles passing over the driveway. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. Setup is a 3-step process: saw a 1/8" slot 1" deep in the pavement, press the loop in, and seal over it. Its 20' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to 3-car-wide residential drives and light commercial entries.

Features:

• Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
• Optimizes read range, eliminates faulty signals, and minimizes callbacks
• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment

Specifications:

• Loop type: Saw cut
• Total loop length: 52'
• Loop dimensions: 6' x 20'
• Lead-in length: 75'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 26'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes