Details

National Loop Co. 50' (6' X 19') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 25' Wide Driveways - X-NL25-18

Built for retrofitting an existing paved driveway, the National Loop Co. 50' Saw Cut Vehicle Detection Loop with Custom Length Lead-In is a factory-wound 18 AWG inductive loop ready to lay into a saw-cut slot. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. Installers saw a 3/16" by 1" deep slot into the existing surface, drop the prewound loop in, and seal the slot against moisture. Its 19' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to estate properties, horse farms, and private road entrances.

Features:

• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

• Loop type: Saw cut
• Total loop length: 50'
• Loop dimensions: 6' x 19'
• Lead-in length: Custom length
• Slot size: 3/16" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 25'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes