Details

National Loop Co. 50' (6' X 19') Saw Cut Vehicle Detection Loop with 75' Lead-In for 25' Wide Driveways - P-NL25-18-75

Because it arrives prewound and precut, the National Loop Co. 50' Saw Cut Vehicle Detection Loop with 75' Lead-In takes the guesswork out of adding vehicle detection to an existing driveway. Once a loop detector reads its signal, the loop covers the non-contact vehicle detection that UL 325 requires as one of the two means of entrapment protection for automated gates. Setup is a 3-step process: saw a 1/8" slot 1" deep in the pavement, press the loop in, and seal over it. Its 19' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to estate properties, horse farms, and private road entrances.

Features:

• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range

Specifications:

• Loop type: Saw cut
• Total loop length: 50'
• Loop dimensions: 6' x 19'
• Lead-in length: 75'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 25'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes