National Loop Co. 48' (6' X 18') Saw Cut Vehicle Detection Loop with 100' Lead-In for 24' Wide Driveways - P-NL24-18-100

National Loop Co. 48' (6' X 18') Saw Cut Vehicle Detection Loop with 100' Lead-In for 24' Wide Driveways - P-NL24-18-100

Sensing traffic through the pavement itself, the National Loop Co. 48' Saw Cut Vehicle Detection Loop with 100' of lead-in wire gives the gate system reliable vehicle detection. Installation calls for a 1" deep slot saw cut into the existing asphalt or concrete, with the loop pressed in and the cut sealed. Its 48' of wire forms a 6' x 18' rectangle sized for 24' wide driveways at 2-car drives with a full walkway and church or small office lot entries.
Part Number: P-NL24-18-100
$172.08 each $172.08 each
OR

Details

National Loop Co. 48' (6' X 18') Saw Cut Vehicle Detection Loop with 100' Lead-In for 24' Wide Driveways - P-NL24-18-100

Designed to sense vehicles without any surface teardown, the National Loop Co. 48' Saw Cut Vehicle Detection Loop with 100' Lead-In is a preformed 18 AWG loop that drops into a saw-cut slot. Once a loop detector reads its signal, the loop provides the non-contact vehicle detection automated gates rely on. Installation calls for sawing a 1/8" slot 1" deep into existing asphalt or concrete, laying the loop in the slot, and sealing it, with no hand-winding or turn counting required. With the 18' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits 2-car plus full walkway and church or small office lot entries.

Features:

  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail

Specifications:

  • Loop type: Saw cut
  • Total loop length: 48'
  • Loop dimensions: 6' x 18'
  • Lead-in length: 100'
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 24'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL24-18-100?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 100'
Loop Length Size 6' X 18'
Total Loop Length 48'
Wire Size 1/8"
SKU P-NL24-18-100
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file