Details

National Loop Co. 40' (6' X 14') Saw Cut Vehicle Detection Loop with 50' Lead-In for 20' Wide Driveways - P-NL20-18-50

Made for gate and access-control upgrades, the National Loop Co. 40' Saw Cut Vehicle Detection Loop with 50' Lead-In is an 18 AWG inductive loop, machine-wound and ready to seal into existing pavement. Wired to compatible automated system, the loop counts as one of the two means of entrapment protection UL 325 requires for gate operators, detecting the metal of any vehicle over the sensing area so the gate stops or reverses before contact. Fitting takes one shallow saw cut: a 1/8" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. With the 14' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits ranch entrances, farm properties, and estate homes with dual swing gates.

Features:

• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range

Specifications:

• Loop type: Saw cut
• Total loop length: 40'
• Loop dimensions: 6' x 14'
• Lead-in length: 50'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 20'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes