Details

National Loop Co. 40' (6' X 14') Saw Cut Vehicle Detection Loop with 225' Lead-In for 20' Wide Driveways - P-NL20-18-225

Contractors reach for the National Loop Co. 40' Saw Cut Vehicle Detection Loop with 225' Lead-In when an existing asphalt or concrete drive needs reliable vehicle detection. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. Setup is a 3-step process: saw a 1/8" slot 1" deep in the pavement, press the loop in, and seal over it. With the 14' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits ranch entrances, farm properties, and estate homes with dual swing gates.

Features:

• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding

Specifications:

• Loop type: Saw cut
• Total loop length: 40'
• Loop dimensions: 6' x 14'
• Lead-in length: 225'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 20'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes