Details

National Loop Co. 38' (6' X 13') Saw Cut Vehicle Detection Loop with 50' Lead-In for 19' Wide Driveways - P-NL19-18-50

A preformed 18 AWG inductive loop built for saw-cut installation, the National Loop Co. 38' Saw Cut Vehicle Detection Loop with 50' Lead-In detects vehicles passing over the driveway. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. The install method is a 1/8" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. With the 13' side crossing the lane and about 3' of clearance per edge, and the 6' side capturing vehicles in the direction of travel, the layout fits 2-car drives with extra walkway room and estate-style rural homes.

Features:

• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding

Specifications:

• Loop type: Saw cut
• Total loop length: 38'
• Loop dimensions: 6' x 13'
• Lead-in length: 50'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 19'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes