Details

National Loop Co. 34' (5' X 12') Saw Cut Vehicle Detection Loop with 200' Lead-In for 17' Wide Driveways - P-NL17-18-200

Retrofit projects move faster with the National Loop Co. 34' Saw Cut Vehicle Detection Loop with 200' Lead-In, a preformed 18 AWG loop that eliminates on-site wire winding. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse, providing one of the two means of entrapment protection UL 325 requires for automated gates. Setup is a 3-step process: saw a 1/8" slot 1" deep in the pavement, press the loop in, and seal over it. Its 12' side spans the travel lane while the 5' side runs in the direction of traffic, leaving roughly 2' 6" of clearance on each edge, an arrangement well suited to 2-car drives in newer subdivisions and homes with boat or trailer parking.

Features:

• Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
• Optimizes read range, eliminates faulty signals, and minimizes callbacks
• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment

Specifications:

• Loop type: Saw cut
• Total loop length: 34'
• Loop dimensions: 5' x 12'
• Lead-in length: 200'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 17'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes