National Loop Co. 34' (5' X 12') Saw Cut Vehicle Detection Loop with 20' Lead-In for 17' Wide Driveways - P-NL17-18-20

National Loop Co. 34' (5' X 12') Saw Cut Vehicle Detection Loop with 20' Lead-In for 17' Wide Driveways - P-NL17-18-20

Monitoring the driveway around the clock, the National Loop Co. 34' Saw Cut Vehicle Detection Loop with its 20' lead-in provides the non-contact vehicle detection automatic gates rely on. A saw, a 1" cut, and a sealant cap put this loop to work in existing pavement. Each loop puts 34' of wire into a 5' x 12' rectangle built for 17' wide driveways, including homes with boat or trailer parking and newer subdivision drives.
Part Number: P-NL17-18-20
$125.39 each $125.39 each
OR
 

Details

National Loop Co. 34' (5' X 12') Saw Cut Vehicle Detection Loop with 20' Lead-In for 17' Wide Driveways - P-NL17-18-20

Built for retrofitting an existing paved driveway, the National Loop Co. 34' Saw Cut Vehicle Detection Loop with 20' Lead-In is a factory-wound 18 AWG inductive loop ready to lay into a saw-cut slot. Teamed with a loop detector, it gives the gate operator the presence detection it needs, so the gate reverses or holds open while a vehicle sits in the path. The install method is a 1/8" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. Its 12' side spans the travel lane while the 5' side runs in the direction of traffic, leaving roughly 2' 6" of clearance on each edge, an arrangement well suited to 2-car drives in newer subdivisions and homes with boat or trailer parking.

Features:

  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

  • Loop type: Saw cut
  • Total loop length: 34'
  • Loop dimensions: 5' x 12'
  • Lead-in length: 20'
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 17'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL17-18-20?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 20'
Loop Length Size 5' X 12'
Total Loop Length 34'
Wire Size 1/8"
SKU P-NL17-18-20
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file