Details

National Loop Co. 34' (5' X 12') Saw Cut Vehicle Detection Loop with 175' Lead-In for 17' Wide Driveways - P-NL17-18-175

Installing the National Loop Co. 34' Saw Cut Vehicle Detection Loop with 175' Lead-In means sawing one slot, laying in a preformed 18 AWG loop, and sealing it. Teamed with a loop detector, it gives the gate operator the presence detection UL 325 counts as one of its two means of entrapment protection, so the gate reverses or holds open while a vehicle sits in the path. Setup is a 3-step process: saw a 1/8" slot 1" deep in the pavement, press the loop in, and seal over it. With the 12' side crossing the lane and about 2' 6" of clearance per edge, and the 5' side capturing vehicles in the direction of travel, the layout fits 2-car drives in newer subdivisions and homes with boat or trailer parking.

Features:

• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system

Specifications:

• Loop type: Saw cut
• Total loop length: 34'
• Loop dimensions: 5' x 12'
• Lead-in length: 175'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 17'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes