National Loop Co. 22' (4' X 7') Saw Cut Vehicle Detection Loop with 250' Lead-In for 11' Wide Driveways - P-NL11-18-250

National Loop Co. 22' (4' X 7') Saw Cut Vehicle Detection Loop with 250' Lead-In for 11' Wide Driveways - P-NL11-18-250

The National Loop Co. 22' Saw Cut Vehicle Detection Loop with 250' Lead-In turns passing traffic into gate commands, opening for cars and trucks without a keypad or remote. Crews cut a narrow channel in the existing driveway, set the factory-wound loop inside, and seal it against moisture. Total wire runs 22' in a 4' x 7' layout, with 18 AWG conductors sized to 11' wide driveways at older neighborhoods with roomier single-car drives, while its 250' lead-in covers long runs to the detector.
Part Number: P-NL11-18-250
$210.74 each $210.74 each
OR
 

Details

National Loop Co. 22' (4' X 7') Saw Cut Vehicle Detection Loop with 250' Lead-In for 11' Wide Driveways - P-NL11-18-250

Sized to match a specific driveway width, the National Loop Co. 22' Saw Cut Vehicle Detection Loop with 250' Lead-In is a factory-wound 18 AWG loop for retrofit installations. Wired to a compatible automated system, the loop detects the metal of any vehicle over the sensing area so the gate stops or reverses before contact. The install method is a 1/8" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. Its 7' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to slightly wider suburban single-car drives and older neighborhoods with wider lot cuts.

Features:

  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations

Specifications:

  • Loop type: Saw cut
  • Total loop length: 22'
  • Loop dimensions: 4' x 7'
  • Lead-in length: 250'
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 11'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL11-18-250?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 250'
Loop Length Size 4' X 7'
Total Loop Length 22'
Wire Size 1/8"
SKU P-NL11-18-250
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file