National Loop Co. 20' (4' X 6') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 10' Wide Driveways - X-NL10-18

National Loop Co. 20' (4' X 6') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 10' Wide Driveways - X-NL10-18

Safety on automatic gates is never optional, and the National Loop Co. 20' Saw Cut Vehicle Detection Loop with a custom length lead-in monitors the drive for traffic of any size. It installs through a 1" deep saw cut in existing asphalt or concrete, so the finished surface stays largely intact. Formed as a 4' x 6' rectangle with 20' of perimeter, it matches the 10' drives found at standard suburban homes and duplex driveways.
Part Number: X-NL10-18

* Required Fields

$117.60 each $117.60 each

Price From: $117.60

Details

National Loop Co. 20' (4' X 6') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 10' Wide Driveways - X-NL10-18

Built for retrofitting an existing paved driveway, the National Loop Co. 20' Saw Cut Vehicle Detection Loop with Custom Length Lead-In is a factory-wound 18 AWG inductive loop ready to lay into a saw-cut slot. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator dependable non-contact detection. Fitting takes one shallow saw cut: a 3/16" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. Its 6' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to standard single-car suburban homes, duplex driveways, and small farm entrances.

Features:

  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
  • Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range

Specifications:

  • Loop type: Saw cut
  • Total loop length: 20'
  • Loop dimensions: 4' x 6'
  • Lead-in length: Custom length
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 10'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL10-18?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Loop Length Size 4' X 6'
Total Loop Length 20'
Wire Size 3/16"
SKU X-NL10-18
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file