Details

National Loop Co. 20' (4' X 6') Saw Cut Vehicle Detection Loop with 125' Lead-In for 10' Wide Driveways - P-NL10-18-125

Built for retrofitting an existing paved driveway, the National Loop Co. 20' Saw Cut Vehicle Detection Loop with 125' Lead-In is a factory-wound 18 AWG inductive loop ready to lay into a saw-cut slot. Teamed with a loop detector, it gives the gate operator the presence detection UL 325 counts as one of its two means of entrapment protection, so the gate reverses or holds open while a vehicle sits in the path. Setup is a 3-step process: saw a 1/8" slot 1" deep in the pavement, press the loop in, and seal over it. Its 6' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to standard single-car suburban homes, duplex driveways, and small farm entrances.

Features:

• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
• Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
• Optimizes read range, eliminates faulty signals, and minimizes callbacks
• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures

Specifications:

• Loop type: Saw cut
• Total loop length: 20'
• Loop dimensions: 4' x 6'
• Lead-in length: 125'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 10'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes