Details

National Loop Co. 20' (4' X 6') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 10' Wide Driveways - P-NL10-18

Gate installers can turn an existing driveway into part of the safety system with the National Loop Co. 20' Saw Cut Vehicle Detection Loop with Custom Length Lead-In, a preformed 18 AWG inductive loop. Teamed with a loop detector, it gives the gate operator the presence detection UL 325 counts as one of its two means of entrapment protection, so the gate reverses or holds open while a vehicle sits in the path. Installers saw a 1/8" by 1" deep slot into the existing surface, drop the prewound loop in, and seal the slot against moisture. With the 6' side crossing the lane and about 2' of clearance per edge, and the 4' side capturing vehicles in the direction of travel, the layout fits standard single-car suburban homes, duplex driveways, and small farm entrances.

Features:

• Optimizes read range, eliminates faulty signals, and minimizes callbacks
• Saves labor cost compared with winding a loop by hand in the field
• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection

Specifications:

• Loop type: Saw cut
• Total loop length: 20'
• Loop dimensions: 4' x 6'
• Lead-in length: Custom length
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 10'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes