Details

National Loop Co. 30' (4' X 11') Saw Cut Vehicle Detection Loop with 150' Lead-In for 15' Wide Driveways - P-NL15-18-150

Gate installers can turn an existing driveway into part of the safety system with the National Loop Co. 30' Saw Cut Vehicle Detection Loop with 150' Lead-In, a preformed 18 AWG inductive loop. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. Fitting takes one shallow saw cut: a 1/8" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. Its 11' side detects a vehicle anywhere across the lane, while the 4' side tracks its passage, with roughly 2' of edge clearance, ideal for standard 2-car driveways on modest suburban lots.

Features:

• Provides the non-contact vehicle detection UL 325 gate systems count toward their two required means of entrapment protection
• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced XLP-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations

Specifications:

• Loop type: Saw cut
• Total loop length: 30'
• Loop dimensions: 4' x 11'
• Lead-in length: 150'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 15'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes