National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with 250' Lead-In for 14' Wide Driveways - P-NL14-18-250

National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with 250' Lead-In for 14' Wide Driveways - P-NL14-18-250

The National Loop Co. 28' Saw Cut Vehicle Detection Loop with 250' of lead-in to reach the detector signals the gate operator the moment traffic appears. It installs through a 1" deep saw cut in existing asphalt or concrete, so the finished surface stays largely intact. Formed as a 4' x 10' rectangle with 28' of perimeter, it matches the 14' drives found at long rural drives and roomy single-car or snug 2-car lots.
Part Number: P-NL14-18-250
$218.51 each $218.51 each
OR

Details

National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with 250' Lead-In for 14' Wide Driveways - P-NL14-18-250

Made for gate and access-control upgrades, the National Loop Co. 28' Saw Cut Vehicle Detection Loop with 250' Lead-In is an 18 AWG inductive loop, machine-wound and ready to seal into existing pavement. Teamed with a loop detector, it gives the gate operator the presence detection it needs, so the gate reverses or holds open while a vehicle sits in the path. The install method is a 1/8" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. Its 10' side spans the travel lane while the 4' side runs in the direction of traffic, leaving roughly 2' of clearance on each edge, an arrangement well suited to wide single-car or tight 2-car driveways and long rural drives.

Features:

  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
  • Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range

Specifications:

  • Loop type: Saw cut
  • Total loop length: 28'
  • Loop dimensions: 4' x 10'
  • Lead-in length: 250'
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 14'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL14-18-250?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 250'
Loop Length Size 4' X 10'
Total Loop Length 28'
Wire Size 1/8"
SKU P-NL14-18-250
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file