National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with 225' Lead-In for 14' Wide Driveways - P-NL14-18-225

National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with 225' Lead-In for 14' Wide Driveways - P-NL14-18-225

No batteries, no lenses, no line of sight, and the National Loop Co. 28' Saw Cut Vehicle Detection Loop with 225' of lead-in to reach the detector spots cars and trucks without any physical contact. Because it arrives preformed, it goes straight into a 1" saw-cut groove without any winding on site. At 28' of total loop length, the 4' x 10' layout fits 14' wide driveways, from long rural drives and roomy single-car or snug 2-car lots.
Part Number: P-NL14-18-225
$208.56 each $208.56 each
OR
 

Details

National Loop Co. 28' (4' X 10') Saw Cut Vehicle Detection Loop with 225' Lead-In for 14' Wide Driveways - P-NL14-18-225

Made for gate and access-control upgrades, the National Loop Co. 28' Saw Cut Vehicle Detection Loop with 225' Lead-In is an 18 AWG inductive loop, machine-wound and ready to seal into existing pavement. Once a loop detector reads its signal, the loop provides the non-contact vehicle detection automated gates rely on. Installation calls for sawing a 1/8" slot 1" deep into existing asphalt or concrete, laying the loop in the slot, and sealing it, with no hand-winding or turn counting required. With the 10' side crossing the lane and about 2' of clearance per edge, and the 4' side capturing vehicles in the direction of travel, the layout fits wide single-car or tight 2-car driveways and long rural drives.

Features:

  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
  • Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range

Specifications:

  • Loop type: Saw cut
  • Total loop length: 28'
  • Loop dimensions: 4' x 10'
  • Lead-in length: 225'
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 14'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL14-18-225?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 225'
Loop Length Size 4' X 10'
Total Loop Length 28'
Wire Size 1/8"
SKU P-NL14-18-225
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file