Details

National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 30' Lead-In for 9' Wide Driveways - P-NL09-18-30

The National Loop Co. 18' Saw Cut Vehicle Detection Loop with 30' Lead-In is a preformed 18 AWG inductive vehicle detection loop that arrives ready to drop into a saw-cut slot. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse, providing one of the two means of entrapment protection UL 325 requires for automated gates. The install method is a 1/8" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. Its 6' side spans the travel lane while the 3' side runs in the direction of traffic, leaving roughly 1' 6" of clearance on each edge, an arrangement well suited to suburban single-car driveways, condo/townhome parking pads, and small ranch homes.

Features:

• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system

Specifications:

• Loop type: Saw cut
• Total loop length: 18'
• Loop dimensions: 3' x 6'
• Lead-in length: 30'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 9'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes