National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 200' Lead-In for 9' Wide Driveways - P-NL09-18-200

National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 200' Lead-In for 9' Wide Driveways - P-NL09-18-200

Sensing traffic through the pavement itself, the National Loop Co. 18' Saw Cut Vehicle Detection Loop with a 200' lead-in gives the gate system reliable vehicle detection. It installs through a 1" deep saw cut in existing asphalt or concrete, so the finished surface stays largely intact. Formed as a 3' x 6' rectangle with 18' of perimeter, it matches the 9' drives found at suburban single-car driveways and condo or townhome parking pads.
Part Number: P-NL09-18-200
$183.02 each $183.02 each
OR

Details

National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 200' Lead-In for 9' Wide Driveways - P-NL09-18-200

The National Loop Co. 18' Saw Cut Vehicle Detection Loop with 200' Lead-In is a preformed 18 AWG inductive vehicle detection loop that arrives ready to drop into a saw-cut slot. Wired to a compatible automated system, the loop detects the metal of any vehicle over the sensing area so the gate stops or reverses before contact. Installers saw a 1/8" by 1" deep slot into the existing surface, drop the prewound loop in, and seal the slot against moisture. Its 6' side spans the travel lane while the 3' side runs in the direction of traffic, leaving roughly 1' 6" of clearance on each edge, an arrangement well suited to suburban single-car driveways, condo/townhome parking pads, and small ranch homes.

Features:

  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
  • Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
  • Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
  • Optimizes read range, eliminates faulty signals, and minimizes callbacks
  • Saves labor cost compared with winding a loop by hand in the field
  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters

Specifications:

  • Loop type: Saw cut
  • Total loop length: 18'
  • Loop dimensions: 3' x 6'
  • Lead-in length: 200'
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 9'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL09-18-200?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 200'
Loop Length Size 3' X 6'
Total Loop Length 18'
Wire Size 1/8"
SKU P-NL09-18-200
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file