National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 100' Lead-In for 9' Wide Driveways - P-NL09-18-100

National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 100' Lead-In for 9' Wide Driveways - P-NL09-18-100

The National Loop Co. 18' Saw Cut Vehicle Detection Loop with 100' of lead-in to reach the detector signals the gate operator the moment traffic appears. Fitting it takes a concrete saw, a 1" slot in the driveway surface, and a bead of sealant over the top. Its footprint of 3' x 6' yields 18' of wire, a fit for 9' wide driveways including small ranch homes and suburban single-car drives.
Part Number: P-NL09-18-100
$130.57 each $130.57 each
OR
 

Details

National Loop Co. 18' (3' X 6') Saw Cut Vehicle Detection Loop with 100' Lead-In for 9' Wide Driveways - P-NL09-18-100

Designed to sense vehicles without any surface teardown, the National Loop Co. 18' Saw Cut Vehicle Detection Loop with 100' Lead-In is a preformed 18 AWG loop that drops into a saw-cut slot. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator dependable non-contact detection. Fitting takes one shallow saw cut: a 1/8" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. Its 6' side spans the travel lane while the 3' side runs in the direction of traffic, leaving roughly 1' 6" of clearance on each edge, an arrangement well suited to suburban single-car driveways, condo/townhome parking pads, and small ranch homes.

Features:

  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations
  • Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
  • Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
  • Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
  • Neatly stacked turns accept loop sealant completely, locking out moisture for long service life

Specifications:

  • Loop type: Saw cut
  • Total loop length: 18'
  • Loop dimensions: 3' x 6'
  • Lead-in length: 100'
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 9'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL09-18-100?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 100'
Loop Length Size 3' X 6'
Total Loop Length 18'
Wire Size 1/8"
SKU P-NL09-18-100
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file