Details

National Loop Co. 16' (2' X 6') Saw Cut Vehicle Detection Loop with 200' Lead-In for 8' Wide Driveways - P-NL08-18-200

Installing the National Loop Co. 16' Saw Cut Vehicle Detection Loop with 200' Lead-In means sawing one slot, laying in a preformed 18 AWG loop, and sealing it. Wired to compatible automated system, the loop counts as one of the two means of entrapment protection UL 325 requires for gate operators, detecting the metal of any vehicle over the sensing area so the gate stops or reverses before contact. Fitting takes one shallow saw cut: a 1/8" slot, 1" deep, cleaned out, filled with the loop, and sealed with loop sealant. Its 6' side spans the travel lane while the 2' side runs in the direction of traffic, leaving roughly 1' of clearance on each edge, an arrangement well suited to older urban row homes, narrow driveways, and single-car gravel drives in rural areas.

Features:

• Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
• One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
• Factory-set turn count means optimal read range without any on-site adjustment
• Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system

Specifications:

• Loop type: Saw cut
• Total loop length: 16'
• Loop dimensions: 2' x 6'
• Lead-in length: 200'
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 8'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes