National Loop Co. 16' (2' X 6') Saw Cut Vehicle Detection Loop with 125' Lead-In for 8' Wide Driveways - P-NL08-18-125

National Loop Co. 16' (2' X 6') Saw Cut Vehicle Detection Loop with 125' Lead-In for 8' Wide Driveways - P-NL08-18-125

Every safe automatic gate starts with reliable detection, and the National Loop Co. 16' Saw Cut Vehicle Detection Loop with 125' of lead-in to reach the detector spots cars and trucks without any physical contact. It installs through a 1" deep saw cut in existing asphalt or concrete, so the finished surface stays largely intact. Formed as a 2' x 6' rectangle with 16' of perimeter, it matches the 8' drives found at single-car gravel drives in rural areas and tight older lots.
Part Number: P-NL08-18-125
$147.95 each $147.95 each
OR

Details

National Loop Co. 16' (2' X 6') Saw Cut Vehicle Detection Loop with 125' Lead-In for 8' Wide Driveways - P-NL08-18-125

Designed to sense vehicles without any surface teardown, the National Loop Co. 16' Saw Cut Vehicle Detection Loop with 125' Lead-In is a preformed 18 AWG loop that drops into a saw-cut slot. Paired with a compatible loop detector, it senses the metal mass of a passing car or truck and signals the gate operator to open, hold, or reverse. The install method is a 1/8" wide, 1" deep saw cut in the existing asphalt or concrete, with the loop laid in and sealed to finish the job. Its 6' side spans the travel lane while the 2' side runs in the direction of traffic, leaving roughly 1' of clearance on each edge, an arrangement well suited to older urban row homes, narrow driveways, and single-car gravel drives in rural areas.

Features:

  • Neatly stacked turns accept loop sealant completely, locking out moisture for long service life
  • Optimizes read range, eliminates faulty signals, and minimizes callbacks
  • Saves labor cost compared with winding a loop by hand in the field
  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment

Specifications:

  • Loop type: Saw cut
  • Total loop length: 16'
  • Loop dimensions: 2' x 6'
  • Lead-in length: 125'
  • Slot size: 1/8" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 8'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number P-NL08-18-125?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Lead-In Length 125'
Loop Length Size 2' X 6'
Total Loop Length 16'
Wire Size 1/8"
SKU P-NL08-18-125
Product Type Saw Cut Preformed Loop
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Material Polypropylene-Wrapped Copper Wires
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file