National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 38' Wide Driveways - X-NL38-18

National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 38' Wide Driveways - X-NL38-18

Sensing traffic through the pavement itself, the National Loop Co. 76' Saw Cut Vehicle Detection Loop with a custom length lead-in provides the non-contact vehicle detection. It drops into a 1" groove in existing pavement, and sealant locks out water once the wire is in place. A 6' x 32' arrangement gives it 76' of total wire, matching 38' wide driveways at wide equipment yards and grain elevators or agricultural co-op entrances.
Part Number: X-NL38-18

* Required Fields

$232.71 each $232.71 each

Price From: $232.71

Details

National Loop Co. 76' (6' X 32') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 38' Wide Driveways - X-NL38-18

Built for retrofitting an existing paved driveway, the National Loop Co. 76' Saw Cut Vehicle Detection Loop with Custom Length Lead-In is a factory-wound 18 AWG inductive loop ready to lay into a saw-cut slot. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator dependable non-contact detection. Setup is a 3-step process: saw a 3/16" slot 1" deep in the pavement, press the loop in, and seal over it. Its 32' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to wide equipment yards, grain elevators, agricultural co-op entrances, and large commercial plaza entries.

Features:

  • Works wherever vehicles need detecting: automatic gates, parking barriers, overhead doors, traffic signals, arming devices, and vehicle counters
  • One continuous, non-spliced Polypropylene-insulated wire runs through the loop turns and lead-in, eliminating splice failures
  • Factory-set turn count means optimal read range without any on-site adjustment
  • Precisely stacked wires let loop sealant fully encapsulate the loop for lasting weather protection
  • Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
  • More cost-effective than hand-wound loop installations

Specifications:

  • Loop type: Saw cut
  • Total loop length: 76'
  • Loop dimensions: 6' x 32'
  • Lead-in length: Custom length
  • Slot size: 3/16" wide x 1" deep
  • Wire gauge: 18 AWG
  • Wire material: Polypropylene-wrapped copper wire
  • Best-suited driveway width: 38'
  • Manufacturer: National Loop Company (NLC)
  • Made in America: Yes
Prefer to Call? (888) 378-1175

Questions about part number X-NL38-18?

Required Fields *

Name *

Email *

Phone

My Questions *

Loop Type Saw Cut
Loop Length Size 6' X 32'
Total Loop Length 76'
Wire Size 3/16"
SKU X-NL38-18
Made In America Tooltip
Learn More About BABA Certification
Yes
Ideal Application Access Control, Arming Devices, Gate Operators, Overhead Doors, Parking Barrier Gates, Traffic Signals, Vehicle Counters
Manufacturer National Loop Company - NLC
Specification Sheet Download PDF file