Details

National Loop Co. 64' (6' X 26') Saw Cut Vehicle Detection Loop with Custom Length Lead-In for 32' Wide Driveways - P-NL32-18

Retrofit projects move faster with the National Loop Co. 64' Saw Cut Vehicle Detection Loop with Custom Length Lead-In, a preformed 18 AWG loop that eliminates on-site wire winding. Connected to a loop detector, it reports every vehicle that crosses the sensing area, giving the gate operator the non-contact detection that fills one of the two UL 325 entrapment protection slots. Installation calls for sawing a 1/8" slot 1" deep into existing asphalt or concrete, laying the loop in the slot, and sealing it, with no hand-winding or turn counting required. Its 26' side spans the travel lane while the 6' side runs in the direction of traffic, leaving roughly 3' of clearance on each edge, an arrangement well suited to light industrial driveways and church or school lot entries.

Features:

• Cuts down on faulty detection calls and repeat service trips thanks to consistent machine winding
• More cost-effective than hand-wound loop installations
• Fills the non-contact detection role UL 325 assigns to vehicle loops in a 2-device entrapment protection system
• Designed for vehicle detection with gate operators, parking barrier gates, overhead doors, traffic signals, arming devices, and vehicle counters
• Wound from one continuous, non-spliced length of Polypropylene-insulated wire, leaving no splice point between the loop and lead-in to fail
• Predetermined number of machine-wound turns removes the guesswork of achieving optimal read range
• Neatly stacked turns accept loop sealant completely, locking out moisture for long service life

Specifications:

• Loop type: Saw cut
• Total loop length: 64'
• Loop dimensions: 6' x 26'
• Lead-in length: Custom length
• Slot size: 1/8" wide x 1" deep
• Wire gauge: 18 AWG
• Wire material: Polypropylene-wrapped copper wire
• Best-suited driveway width: 32'
• Manufacturer: National Loop Company (NLC)
• Made in America: Yes